Propellerhead Reason - 4.0 Manual de operaciones descargar pdf (Pagina 96)

THE SEQUENCER

Automating tempo and time

signature

The transport track can be used to automate tempo and/or time signature changes. It

works by drawing or recording clips on automation lanes for the transport track.

Automating tempo

Automating tempo is done much in the same way as with other automation. You can

either record the tempo changes by changing the tempo on the transport panel, or

you can draw curves in clips on the transport track.

1. Set the desired tempo on the transport.

This will be your static value, i.e. the tempo of the song wherever there is no clip

present on the automation lane.

2. [Alt]/[Option]-click in the Tempo field on the transport panel.

This will select the Transport track and create a Tempo automation lane in one go.

From here you can decide whether to draw clips where you want the tempo to change

or to record automation clips by manually changing the Tempo controls on the trans-

port. We will describe how to draw tempo automation clips.

D It is generally a good idea to activate Snap and have the snap value set

to Bar when drawing clips.

3. Select the Pencil tool and draw a clip over the area where you want the

tempo to change.

4. With the clip selected, press [Return] to open it for editing.

If you like, you can switch to Edit mode - this allows you to edit the static tempo

value too.

Now you can draw automation curves in the normal way.

D Remember that Snap applies when inserting points.

You can also change the position of a point numerically in the Inspector.

Here, the tempo changes from 120 to 150 over four bars.

D If you press [Alt]/[Option] you can draw automation ranges for instant

changes between tempo values.

✪ Even though Reason supports a very wide tempo range, editing is by de-

fault restricted to the range 60 - 250 bpm. This is only to make it easier to

work with small tempo changes - if you want lower or higher tempi you

can change the range by double clicking the min or max value (“60” or

“250” in the picture above) and typing in new values.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 401 402

Sin comentarios

Propellerhead Reason - 4.0 Manual de operaciones Pagina 96