Propellerhead Reason - 4.0 Manual de operaciones descargar pdf (Pagina 169)

THE MIXER

167

Connections

All input and output connectors are as usual located on the back panel of the Mixer

14:2. Special connectors are used for “chaining” two or more Mixers together. This is

described on page 168.

Mixer Channel Connections

D Each mixer channel features stereo left/right inputs for connecting audio

devices.

Use the left input when manually connecting a mono signal source.

D In addition, there are two Control Voltage (CV) inputs (with associated

voltage trim pots), for voltage controlling channel Level and Pan from

other devices.

Auxiliary (AUX) Send Out

D There are four stereo Send Out connectors, which normally are used to

connect to the inputs of effect devices.

To connect a send to a mono-input device, use the Left (Mono) output.

When a Send is connected to an effects device, the corresponding AUX Send knob

determines the level of the signal sent to the effect device for each channel. The Send

Output is taken post-channel fader but you have the option of selecting pre-fader

mode for AUX Send 4.

D Note that some effects (for example the Comp-01 compressor or the

PEQ2 parametric EQ) are effect types which are not designed to be used

as AUX Send effects, but rather as insert effects, where the whole signal

is passed through the effect.

Alternatively, you could use AUX Send 4 in pre-fader mode and lower the channel

fader completely.

Auxiliary (AUX) Returns

D There are four stereo Return input connectors.

These are normally connected to the left and right outputs of effect devices.

Master Left/Right Outputs

D The Master outputs are auto-routed to the first available input pair on

the Audio Hardware interface.

This in turn sends the audio to the outputs of your audio hardware.

✪ Note that the Master outputs don’t have to be routed directly to the Au-

dio Hardware Interface. You could for example route the Master outputs

to an effect, and then route the effect outputs to the Hardware Interface

instead.

D In addition, there is a Control Voltage (CV) input (and an associated trim

pot), for voltage controlling the Master Level from another device.

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 401 402

Sin comentarios

Propellerhead Reason - 4.0 Manual de operaciones Pagina 169