Propellerhead Reason - 4.0 Manual de operaciones descargar pdf (Pagina 127)

USING REASON AS A REWIRE SLAVE

125

Launching and Quitting

When using Rewire, the launch and quit order is very important:

Launching for normal use with ReWire

1. First launch the host application.

2. Then launch Reason.

Quitting a ReWire session

When you are finished, you also need to Quit the applications in a special order:

1. First quit Reason.

2. Then quit the host application.

Launching the host application for use without Reason/ReWire

If you don’t plan to run Reason, just launch the host application as usual. We recom-

mend that you then also deactivate all ReWire channels if required (see the relevant

section for your program, below). But this is not completely critical, ReWire does not

use up very much processing power when it isn’t used.

Launching Reason for use without the host application

If you want to use Reason as it is, without ReWire, just launch it as you normally do.

Launching both programs without using ReWire

We don’t know exactly why you would want to run Reason and a Rewire host applica-

tion at the same time on the same computer, without using ReWire, but you can:

1. First launch Reason.

2. Then launch the host application.

You may get a warning message in the host application, regarding ReWire, but you

can safely ignore it. Please also note that the two programs now compete for system

resources such as audio cards, just as when running either with other, non-ReWire,

audio applications.

Using the Transport and

Tempo Controls

Basic Transport Controls

When you run ReWire, the transports in the two programs are completely linked. It

doesn’t matter in which program you Play, Stop, Fast Forward or Rewind. Recording,

however, is still completely separate in the two applications.

Loop Settings

The Loop in Reason and the corresponding feature (Loop, Cycle etc) in the host ap-

plication are also linked. This means that you can move the start and end point for the

Loop/Cycle or turn the Loop/Cycle on/off in either program, and this will be reflected

in the other.

Tempo Settings

As far as tempo goes, the host application is always the Master. This means that both

program will run in the tempo set in the host application.

However, if you are not using automated tempo changes in the host application, you

can adjust the tempo on the transport in either program, and this will immediately be

reflected in the other.

! If you are using the automated tempo changes in the host application, do

not adjust the tempo on the Reason transport, since that tempo the

doesn’t have any effect on playback!

Synchronization

All synchronization to other equipment is handled from the host application, not Rea-

son. In fact there are no special synchronization issues. All that is said in the host ap-

plication’s documentation about synchronizing audio channels is true for ReWire

channels as well.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 401 402

Comentarios a estos manuales

Sin comentarios

Propellerhead Reason - 4.0 Manual de operaciones Pagina 127

Comentarios a estos manuales

Relacionado con productos y manuales para Software Propellerhead Reason - 4.0