Propellerhead Reason - 4.0 Manual de operaciones descargar pdf (Pagina 219)

THOR POLYSONIC SYNTHESIZER

217

The upper half of the menu contains Voice section source parameters, and the lower

half contains various global play and performance-oriented source parameters and

the Global Envelope, as well as the Step Sequencer, CV and Audio inputs.

3. Select “LFO 1” from the pop-up.

This means that LFO 1 is the modulation Source, and this can now be assigned to

modulate a Destination parameter.

4. Pull down the “Dest” column pop-up in the top row.

A pop-up menu appears listing all available modulation Destinations. The upper half of

the menu contains Voice section destinations, and the lower half contains Global sec-

tion destinations, as well as the Step Sequencer, CV and Audio outputs.

5. Select “Osc 1” from the menu and then “Pitch” from the submenu.

This means that Osc 1 pitch is now assigned to be modulated by LFO 1. Next step is

to set the amount of modulation to be applied.

6. Click in the top row Amount column to the right of the Source column, and

move the mouse pointer up and down to set an Amount value.

Both positive and negative Amount values can be set (+/- 100%).

D If you now play a few notes you can hear the oscillator pitch being mod-

ulated by the LFO to produce vibrato.

But the vibrato will be constant, which you probably don’t want. This is solved by

assigning a Scale parameter, which allows you to assign another parameter to

control the modulation Amount.

7. Pull down the “Scale” column pop-up in the top row.

A pop-up menu appears listing all available Scale parameters. The upper half of the

menu contains Voice section parameters, and the lower half contains various play and

performance-oriented parameters and the Global Envelope, as well as the Step Se-

quencer, CV and Audio inputs.

A typical controller for vibrato is the Mod wheel.

8. Select “Performance” from the menu and then “Mod wheel” from the sub-

menu.

This means that Osc 1 pitch is now assigned to be modulated by LFO 1, and the

amount of modulation is controlled by the Mod wheel. How much the Scale parameter

controls the Amount is set using the “Amount” column for the top row (to the left of

the Scale column).

9. Click in the top row Amount column and move the mouse pointer up and

down to set an Amount value.

Both positive and negative Scale Amount values can be set (+/- 100%). To fully

control the LFO modulation so that there is no vibrato when the Mod wheel is set

to zero, set the Amount to 100%.

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 401 402

Sin comentarios

Propellerhead Reason - 4.0 Manual de operaciones Pagina 219