Propellerhead Reason - 4.0 Manual de operaciones descargar pdf (Pagina 255)

NN-19 SAMPLER

253

Voice Spread

This parameter can be used to control the stereo (pan) position of voices. The Spread

knob determines the intensity of the panning. If this is set to “0”, no panning will take

place. The following pan modes can be selected:

Low Bandwidth

This will remove some high frequency content from the sound, but often this is not no-

ticeable (this is especially true if you have “filtered down” samples). Activating this

mode will save you some extra computer power, if needed.

Controller Section

NN-19 can receive common MIDI controller messages, and route these to various pa-

rameters. The following MIDI messages can be received:

• Aftertouch (Channel Pressure)

• Expression Pedal

• Breath Control

If your MIDI keyboard is capable of sending Aftertouch messages, or if you have ac-

cess to an Expression Pedal or a Breath controller, you can use these to modulate

NN-19 parameters. The “Source” selector switch determines which of these mes-

sage-types should be received.

These messages can then be assigned to control the following parameters:

Connections

On the back panel of the NN-19 you will find the connectors, which are mostly CV/

Gate related.

Audio Outputs

These are the main left and right audio outputs. When you create a new NN-19 de-

vice, these are auto-routed to the first available channel on the audio mixer.

Mono Sequencer Control

These are the main CV/Gate inputs. CV controls the note pitch. Gate inputs trigger

note on/off values plus a level, which can be likened to a velocity value. If you want to

control the NN-19 from a Matrix Pattern Sequencer for example, you would normally

use these inputs. The inputs are “mono”, i.e. they control one voice in the sampler.

Modulation Inputs

! Remember that CV connections will not be stored in the sample patch,

even if the connections are to/from the same NN-19 device!

These control voltage (CV) inputs (with associated voltage trim pots), can modulate

various NN-19 parameters from other devices, or from the modulation outputs of the

same NN-19 device. These inputs can control the following parameters:

• Osc (sample) Pitch

• Filter Cutoff

• Filter Resonance

• Amp Level

• Mod Wheel

Modulation Outputs

The Modulation outputs can be used to voltage control other devices, or other param-

eters in the same NN-19 device. The Modulation Outputs are:

• Filter Envelope

• LFO

Mode

Description

Key This will shift the pan position gradually from left to right the higher up on

the keyboard you play.

Key 2 This will shift the pan position from left to right in 8 steps (1/2 octave) for

each consecutive higher note you play, and then repeat the cycle.

Jump This will alternate the pan position from left to right for each note played.

F. Freq This sets external modulation control of the filter frequency parameter. A

positive value will increase the frequency with higher external modulation

values. Negative values invert this relationship.

LFO 1 This sets external modulation control of the LFO Amount parameter. A

positive value will increase the LFO amount with higher external modula-

tion values. Negative values invert this relationship.

Amp This let’s you control the overall volume of the sound with external modu-

lation. If a positive value is set, the volume will increase with higher exter-

nal modulation values. A negative value inverts this relationship.

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 401 402

Comentarios a estos manuales

Sin comentarios

Propellerhead Reason - 4.0 Manual de operaciones Pagina 255

Comentarios a estos manuales

Relacionado con productos y manuales para Software Propellerhead Reason - 4.0