Propellerhead Reason - 4.0 Manual de operaciones descargar pdf (Pagina 89)

THE SEQUENCER

Editing performance controller automation

To edit, draw or delete performance controllers, open the note clip.

Performance controllers (in this case, Mod wheel) are shown on separate edit lanes at

the bottom of the open note clip. The performance controller curves are also indicated

in the overview (top), and the clip in Arrange mode.

• You edit performance controller data just like regular automation.

• You can create or delete performance controller lanes for any parameter using the

pop-up menu on the right side bar of the note edit lane. This works the same way

as for track parameter automation except you cannot mute or delete performance

automation from the track list - see “Adding/removing automation lanes”.

Special case scenario

Although very unlikely, it is possible to have overlapping track parameter and perfor-

mance automation for the same parameter. In such an event, the track parameter au-

tomation overrides the performance automation. As soon as the track parameter clip

ends any performance automation in the clip takes over.

Editing Pattern Change clips

Pattern change clips are viewed and edited in the Pattern Select lane, which is avail-

able on Redrum tracks and Matrix tracks:

A pattern change is shown as clips with a pop-up menu area at the top (given the clip

is selected).

D When you record pattern change clips, they are automatically positioned

on downbeats (at the beginning of new bars) regardless of the Snap set-

ting.

See “Recording pattern changes”.

D If clips aren’t continuous on the pattern change lane the pattern device

will be silent where there is no clip.

Manually adding a Pattern Select lane

A Pattern Select lane is automatically created when recording pattern automation, but

if you prefer you can create an empty Pattern lane in the following ways:

1. Select the pattern device.

Make sure no clips are selected

2. Click the “Create Pattern Select Lane” button on the toolbar.

D You can also [Alt]/[Option]-click on the Pattern select buttons to create

a Pattern Select lane.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 401 402

Sin comentarios

Propellerhead Reason - 4.0 Manual de operaciones Pagina 89