Propellerhead Reason - 4.0 Manual de operaciones descargar pdf (Pagina 70)

THE SEQUENCER

3. Stop recording when you are done.

You have now replaced the automation from where you started recording to where

you stopped recording. The Automation Override indicator will still be lit but it will

go off if you click stop or play on the transport.

D You can also click the Reset button below the Automation Override indi-

cator during recording.

This “resets” the parameter and the automation recording will stop (making the

previously recorded automation active again, from that position). You are still in

record mode, so as soon as you adjust the parameter again, the Automation Over-

ride indicator will light up and a new clip will be created.

Basically, clicking the Reset button is the same as stopping recording and starting

recording again.

D How to edit automation events is described on page 84.

D See “Adding/removing automation lanes” for a description of how to

manually add parameter automation lanes.

Moving automated parameters during playback - “Live mode”

Even if you have automated a parameter, you can still “grab it” and adjust it during

playback, overriding the automation:

1. During playback, adjust an automated parameter.

The Automation Override indicator lights up on the transport panel. From this point

onward, the recorded automation for the parameter is disabled.

2. To activate the automation again, click the Reset button.

This returns control of the parameter to the sequencer.

Recording automation on multiple tracks

Although only one track can have Master Keyboard input, it is possible to record en-

able any number of tracks for automation recording.

D Simply activate the Automation Record Enable button for the tracks you

wish to record automation for.

D When recording is activated, all automation record enabled tracks will

record track parameter changes from their respective devices in the rack.

This is especially useful if you have multiple control surfaces, controlling different

devices in the rack while you’re recording. See the Remote control chapter for de-

tails.

Switching track parameter automation lanes off and on

You can switch off automation lanes by clicking the yellow “On” for a lane button so it

goes dark. This will freeze whatever value the parameter had when switching off the

automation lane. Clicking the button again reactivates the automation.

Deleting automation lanes

Deleting an automation lane is done by clicking the “X” button so it goes dark. If the

lane has clips on it a dialog appears where you have the option to cancel or proceed

with the operation.

Folding automation lanes

You can fold all automation lanes for a track which can make the arrangements a lot

less cluttered if you use automation extensively.

D To fold all automation lanes, click the arrow on the handle of the top au-

tomation lane.

All automation lanes will be folded, and clips on the lanes will be displayed as thin

horizontal strips, just like note clips for folded tracks.

D Pressing [Alt] and clicking on the arrow will fold/unfold the automation

lanes on all tracks.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 401 402

Comentarios a estos manuales

Sin comentarios

Propellerhead Reason - 4.0 Manual de operaciones Pagina 70

Comentarios a estos manuales

Relacionado con productos y manuales para Software Propellerhead Reason - 4.0