Propellerhead Reason - 1.0.1 Manual de operaciones descargar pdf (Pagina 45)

ROUTING MIDI TO REASON

4. Open the MIDI input pop-up for the MIDI Input port(s) that should re-

ceive the incoming MIDI, and select the LB port that you set up in

step 3.

Note that the Sequencer Port only receives MIDI on one selected chan-

nel at a time.

Selecting a HLD port.

Controlling Devices

directly via MIDI

Routing MIDI to Devices

Depending on your MIDI interface, up to four separate ports, each with 16

channels, can be routed to Reason’s External Control inputs. The following

applies regarding setting up the External Control buses:

➜ One port/device can be routed to each separate Bus input.

Simply select the port/device using the appropriate Bus pop-up menu in

the External Control section. One port/device can be routed to several

Bus inputs.

➜ When you have routed several MIDI ports/devices to corresponding

External Buses, you use the Bus Select switch in the MIDI In Device

to select a Bus (A-D) for editing the channel to device routing etc.

If you would like to use an external sequencer to control Reason, there are

basically two scenarios that could apply:

➜ You have a “stand-alone” hardware sequencer or sequencer soft-

ware installed on another computer.

In this case, you should route the MIDI output from the sequencer (or the

MIDI interface on the “other” computer) to the MIDI input on the interface

connected to Reason. You should choose the External Control bus in-

puts for the incoming MIDI. This data is then routed to devices via Rea-

son’s MIDI In device.

➜ You have sequencer software installed on the same computer as

Reason.

This requires the “OMS IAC Driver” under MacOS, or Hubi’s Loopback

Device (or similar) under Windows, as explained in the previous section

of this chapter.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 206 207

Sin comentarios

Propellerhead Reason - 1.0.1 Manual de operaciones Pagina 45