Propellerhead Reason - 1.0.1 Manual de operaciones descargar pdf (Pagina 145)

DR. REX LOOP PLAYER

143

Connections

On the back panel of Dr.Rex you will find the connectors, which are mostly

CV/Gate related. Using CV/Gate is described in the chapter “Routing Audio

and CV”.

Audio Outputs

These are the main left and right audio outputs. When you create a new

Dr.Rex device, these are auto-routed to the first available channels on the

audio mixer.

Slice Gate Output

This outputs a gate signal for each triggered slice in the loop.

Modulation Inputs

These control voltage (CV) inputs (with associated voltage trim pots), allow

you to modulate various Dr.Rex parameters from other devices (or from the

modulation outputs of the Dr.Rex device itself). The following CV inputs are

available:

• Osc Pitch.

• Filter Cutoff.

• Filter Resonance.

• Amp Level.

• Mod Wheel.

Modulation Outputs

The Modulation outputs can be used to voltage control other devices, or

other parameters in the Dr.Rex device itself. The Modulation Outputs are:

• Filter Envelope.

• LFO.

Gate Inputs

These inputs can receive a CV/gate signal to trigger the two envelopes. Note

that connecting to these inputs will override the “normal” triggering of the en-

velopes. For example, if you connected an LFO CV output on another device

to the Gate Amp input on the Dr.Rex, the amplitude envelope would not be

triggered by the incoming MIDI notes to the Dr.Rex device, but by the LFO

CV signal. In addition you would only hear the LFO triggering the envelope

for the slices that were playing at the moment of the trigger.

• Amp Envelope

• Filter Envelope

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 206 207

Sin comentarios

Propellerhead Reason - 1.0.1 Manual de operaciones Pagina 145