Propellerhead Reason - 2.0 Manual de operaciones descargar pdf (Pagina 221)

The Effect Devices

219

COMP-01 Auto Make-up

Gain Compressor

The COMP-01 compressor levels out the audio, by making loud sounds softer.

To compensate for the volume loss, the device has an automatic make-up gain,

that raises the overall level by a suitable amount. The result is that the audio lev-

els become more even and individual sounds can get more “power” and longer

sustain.

The COMP-01 should be used as an insert effect, either for a single instrument

device or for a whole mix (e.g. inserted between a Mixer device and the Hard-

ware Interface).

Parameters

There are no CV inputs for the Compressor.

Parameter

Description

Ratio This lets you specify the amount of gain reduction applied to

the signals above the set threshold. The value is expressed as

a ratio, from 1:1 (no reduction) to 16:1 (levels above the

threshold are reduced by a factor 16).

Threshold This is the threshold level above which the compression sets

in. Signals with levels above the threshold will be affected, sig-

nals below it will not.

In practice, this means that the lower the Threshold setting, the

more the compressor effect.

Attack This governs how quickly the compressor will apply its effect

when signals rise above the set threshold. If you raise this

value, the response will be slower, allowing more of the signal

to pass through the compressor unaffected. Typically, this is

used for preserving the attacks of the sounds.

Release When the signal level drops below the set threshold, this de-

termines how long it takes before the compressor lets the

sound through unaffected. Set this to short values for intense,

“pumping” compressor effects, or to longer values for a

smoother change of the dynamics.

Gain meter This shows the amount of gain reduction or increase (in dB),

caused by the combined compression and make-up gain.

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 265 266

Sin comentarios

Propellerhead Reason - 2.0 Manual de operaciones Pagina 221