Propellerhead Reason - 3.0 - Control Surface Details Guía de usuario descargar pdf (Pagina 18)

Oxygen 8

Requirements/Setting up:

There are two codecs (Remote drivers) for the Oxygen 8: "older model" and "newer

model". Here's why: Reason uses factory preset 1 in the Oxygen 8, but we have

found that there are two different models of the Oxygen 8, with different factory preset

settings. So, which codec to choose depends on the model of your Oxygen 8. Here's

what you should do:

1. Connect the Oxygen 8 via USB or MIDI.

2. Select preset 1 and make sure this isn't changed from the factory settings.

3. If needed, you can restore all presets to factory settings by holding down the

MIDI/Select button while you turn on the Oxygen 8 (note that this restores all

presets, removing any changes you have made!).

4. Add the keyboard as an "Oxygen 8 (older model)" and check whether it

works OK.

For a quick check, set master keyboard input to a Subtractor device and move

knob 1 - this should control the frequency slider of filter 1.

5. If this doesn't work, delete the Oxygen 8 from the control surfaces list and

add it again, this time as an "Oxygen 8 (newer model)".

! The two codecs are identical in regards to the functions and mapping.

Below, the factory settings for the knobs in preset 1 are listed. You can use these lists

to check whether your Oxygen 8 is an "older" or "newer" model. You can also use the

lists to reprogram the knobs manually (if you don't want to restore all presets to fac-

tory defaults):

About the default mapping:

D Note that the Data Entry Fader controls master level on many devices.

D Keyboard shortcut variations are used for devices with many parameters.

Radium 49/61

Requirements/Setting up:

• The Radium 49 and Radium 61 are identical, except for the length of the keyboard.

To use a Radium keyboard with Reason, you need to select preset 1 and make

sure this hasn't been changed from the factory default settings.

• You can restore all presets to factory settings by holding down the MIDI/Select

button while you turn on the Radium (note that this restores all presets, removing

any changes you have made!).

• The Radium keyboard must be added manually - it cannot be found by auto-detect.

About the default mapping:

D Note that the Data Entry Fader controls master level on many devices.

D Keyboard shortcut variations are used for devices with many parameters.

|Oxygen 8 |older model |newer model

Knob 1 MIDI CC 10 MIDI CC 74

Knob 2 MIDI CC 11 MIDI CC 71

Knob 3 MIDI CC 12 MIDI CC 81

Knob 4 MIDI CC 13 MIDI CC 91

Knob 5 MIDI CC 14 MIDI CC 16

Knob 6 MIDI CC 15 MIDI CC 80

Knob 7 MIDI CC 16 MIDI CC 19

Knob 8 MIDI CC 17 MIDI CC 02

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Comentarios a estos manuales

Sin comentarios

Propellerhead Reason - 3.0 - Control Surface Details Guía de usuario Pagina 18

Comentarios a estos manuales